header

 

Fuselage

 

The fuselage starts its life as a sheet panel; it is then cut and predrilled on a CNC router.

Wooden formers are used to hold the cut parts while they are bent into the correct shape. The use of formers ensures that each and every part is reproduced accurately.

The bulkhead pieces are assembled on a steel spine, with each bulkhead adjusted to sit in the correct location. Stringers are riveted into place.

The skins are then put on with temporary rivets, at each stage of assembly there is multiple checks done to maintain the correct alignment of the air frame.


The upper skins or turtle decks are then removed to allow the builder access when assembling the kit.


 


 

Supermarine Aircraft LLC
365 FM 2807
Cisco, Texas 76437

spitfire@supermarineaircraft.com

Phone(254)442-1800
Fax (254)442-1807

All Rights Reserved, 2012